Front/Back Protective Grille
Insert the Metal Spudger between the rubber edge on the grille and the aluminum casing.
Step 2
Slowly pry up the grille until the two tabs shown pop out.
Step 3
The grille is attached to the speaker with double sided sticky tape. To remove the grill gently pull upward while keeping tension to the right.
note:Be very gentle, the grille will bend.
Step 4
Repeat steps to remove the back grille
Step 5
Battery Cover
Remove the four 15.0 mm screws on the left and the four 9.0 mm screws on the right using the T8 Torx Screwdriver.
Step 6
Remove the circuit board by pushing it with your index finger in the direction shown while using a nylon or metal spudger to lift it up and out of place.
Step 7
Carefully pull on the battery cover until the rubber tab slides out of the aluminum casing.
Q: 088772 088789 088796 Bose Soundlink Mini 2 battery
A:how do i reattach the rubber battery cover if i have removed it completely
Q:I had the same problem. If the little rubber tab is not damaged (mine was fine), you should be able to follow these instructions to replace it. But I have these comments on the instructions:
1) You do NOT need to remove the front grill. I have no idea why they suggest you do that here.
2) I think the reason you remove the battery is to make sure the circuit board has zero power on it when you work on it — otherwise a touch of the screwdriver to an unlucky spot on the board might short/burn something out. But I don’t think there’s any mechanical reason to remove it.
3) Once you pop off the back grill cover, you should be able to slide the tab through the slot and coax it up (maybe with a tooth-pick and/or tweezers) on top of the circuit board, but it’s probably better to unscrew the circuit board (as directed here) which makes it easier to push the rubber tab through. Then slide the circuit board back under the tab and screw it back into place.
.jpg)
No comments:
Post a Comment